I'm not sure if this one meets your CFM requirements, but I like my little California Air Tools compressor (4-HP, 220V, single phase):
LinkI've had mine for about two years with no issues. Quieter than most compressors. It keeps up with my plasma cutter just fine. The auto drain feature is nice. Time will tell if this was a good purchase or not.
I have a smaller compressor made by the same company that has been running for the last ten years without fail (knock on wood). I've run the snot out of it.
Both compressors are used for side-hustle purposes. If I was using them full-time, like in an actual business, I would have probably splurged for something larger.