Cost effective network contractor

437 Views | 4 Replies | Last: 5 days ago by Boozer92
BANA89
User Profile
Private Message
Ignore User Stop Ignoring
How long do you want to ignore this user?
24 hours One week Permanently Cancel
6:33p, 1/5/25
AG
Simple probably quick project to configure an Edge
Router 4 for load balancing and failover for two ISP sources. Basically, we have crap options where I live and I'm tired of manual switching back and forth. Any independent guys you might recommend?
BANA Class of '86/'89 - Living in Aggieland!
Reply Quote
Boozer92
User Profile
Private Message
Ignore User Stop Ignoring
How long do you want to ignore this user?
24 hours One week Permanently Cancel
9:00p, 1/5/25
AG
Edge Router 4 has a built in profile for this. Unless you have a ton more other needs you can do that yourself with a couple of clicks
Reply Quote
1
BANA89
User Profile
Private Message
Ignore User Stop Ignoring
How long do you want to ignore this user?
24 hours One week Permanently Cancel
8:02a, 1/6/25
AG
Yeah, I tried a bit yesterday but paused my efforts when the wheel spinning got frustrating. Might try again today with a fresh batch of coffee and freezing weather outside.
BANA Class of '86/'89 - Living in Aggieland!
Reply Quote
halibut sinclair
User Profile Ignore User Stop Ignoring
How long do you want to ignore this user?
24 hours One week Permanently Cancel
8:06a, 1/6/25
Lindsay Communications?
Reply Quote
Boozer92
User Profile
Private Message
Ignore User Stop Ignoring
How long do you want to ignore this user?
24 hours One week Permanently Cancel
In reply to BANA89 • 9:39a, 1/6/25
AG
It has been some time since I have run the wizard but my recollection was that you had to use eth0 and eth1 for wan ports
Reply Quote
Refresh
Page 1 of 1
 
×
subscribe Verify your student status
See Subscription Benefits
Trial only available to users who have never subscribed or participated in a previous trial.